L2501 rear remotes

Stomper

Member

Equipment
2017 L2501. Landpride Mower. Farm King Snow Blower. DIY Root Bucket grapple.
Jun 30, 2017
240
6
18
Northern Canada
I have a L2501 that I reciently installed a third function on for use with my grapple. I am thinking of installing rear remotes. Where would I tie into the hydaulic system for this. For the third function I tied into the power beyond port from the FEL valve. For the rear remotes would I tie into the power beyond from the third function valve or could I "T" into the line that goes from the power beyond from the loader valve to the third function.
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,294
4,853
113
Sandpoint, ID
Never a tee, the whole system must be a loop, so for the rear remotes, you use a Power beyond in and out. ;)
 

Stomper

Member

Equipment
2017 L2501. Landpride Mower. Farm King Snow Blower. DIY Root Bucket grapple.
Jun 30, 2017
240
6
18
Northern Canada
Thanks for the reply Wolfman.
So just to clarify things, I would go from the power beyond BY port on my 3rd function valve to the in P port on the rear remote valve, which is going back to tank right now, and them from the tank T port on the rear remote valve back to the tank and the the A and B ports would go to the rear remotes. Correct
 
Last edited: