B7510 needs new tires, these are R4s. Does anyone know what size hole is in the wheel, front and rear, for the valve stem ? Would like to get them ahead of time just in case. Looked at Kubota parts site, the valve stem is not even listed. Thanks for any info.
Valve stem
- Thread starter SwampCat
- Start date
The bolt in style come with rubber gaskets to fit different size holes. I don’t use the rubber pull in style because I’ve had a couple of rubber ones dry rot over the years and leave me stranded.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Sorry I don't know the size but I do know you can get them at NAPA, I think there is 2 sizes, get both then return the ones that don't fit.
85Hokie
Moderator
Staff member
Lifetime Member
Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
Cat,
not sure on yours - but typical stems are .453" or .625"
https://www.tirerack.com/tires/tiretech/techpage.jsp?techid=208
Last edited: