Will a KUFD110 kubota plow fit a B7100 HST?

Yes this will fit, I don't see the sub frame in any of the pictures so it will need to be made and you can hook your hydraulics up off the tap block on the right side of the tractor, for $100 bucks it a good buy, they are made by ARPS and built heavy.

Big Kahuna

My B7100D manual drive came with the KUFD110, so yes it will fit. Just off of the top of my head, here are the things you will be missing: left and right cylinders, up and down cylinder, the upper mount for the up and down cylinder, the sub frame for the bottom of your tractor to connect the back of the push bar, the hydraulic control valve and mount.

Here are some pictures of my tractor with it mounted:

https://picasaweb.google.com/110263893958737890068/B7100KubotaWithFrontBlade#

John in VA

This is the best picture I have. It is all of the parts from my FEL, dozer, tiller and snow blower after they had been sand blasted and powder coated. The dozer subframe is just this side of the snow blower auger. The back attaches to three bolts (on each side) on the bottom and front of the back axle casting. The front attaches to three bolts (on each side) on the engine chassis. If I remember right, the cross piece in the front to attach to the blade arms is made up primarily of 3x3x1/4" angle. The main frame is similar to my FEL sub frame, just the angle for the dozer arms are attached in a different place than the support arms for the FEL.

Good luck,
John in VA

That is true. That is why many of us have set our mmm aside and use rear finish mowers so that we don't have to take off our sub-frames. I even modified my FEL sub-frame so I could use it with the dozer blade and not have to switch sub-frames.

John in VA