I need to replace the battery bracket on my L275. It's rusted well beyond repair. I'd imagine that it is a common part among many different models. I did an ebay search for L275 battery bracket, but nothing came up. A quick look on Messicks didn't return anything either. Any recommendations where to look?
L275 rusted out battery support bracket
- Thread starter timsch
- Start date
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA
Coleman Equipment Internet Parts
877-851-3647
or
parts@colemanequip.com
Call them and tell them what you need, they will ship it to your front door.
877-851-3647
or
parts@colemanequip.com
Call them and tell them what you need, they will ship it to your front door.
shootem604
Member
Lifetime Member
Equipment
L245DT with Kubota (Arps Model 22) FEL and Kubota B/L4520B (Woods 650) BH
Your local autoparts store will likely also sell battery trays and hold downs. I didn't worry about getting the specific OEM part for my L245.
Not sure which part you are refering to, but if it is the tray, I could not find one for my L1500 (L175).
Attachments
Russell King
Well-known member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
You can try salvage yards like west Kentucky tractor salvage.
I did find one for my L185 but the dealer located it at some other dealers stock and I had to contact them to buy it directly.
You can probably just have a fabricator make a new one or fix the one you have. On mine the side supports were ok, it was the pan that was basically gone and needed to be replaced
Sent from my iPad using Tapatalk
I did find one for my L185 but the dealer located it at some other dealers stock and I had to contact them to buy it directly.
You can probably just have a fabricator make a new one or fix the one you have. On mine the side supports were ok, it was the pan that was basically gone and needed to be replaced
Sent from my iPad using Tapatalk
It's item #6, battery support, that I need. Worse comes to worst, I can just clean up what's left of it and weld on what I need to make it work. The bracket going up to hold the air cleaner is half shot as well. This is the only area with rust to this extent. Battery electrolyte must have leaked out at some point.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Nice fabrication job, too bad you couldn't get stainless steel. I made a tray from 1/8" steel and painted it with POR 15... Will see if it lasts. I found an OEM angle iron battery "hold down" and bought it. The powder coat flaked off in less than 3 months... I wonder if Aluminum would be an alternative?
I wish I could take all the credit, but a quick search would prove me a liar !
http://www.orangetractortalks.com/forums/showpost.php?p=182734&postcount=2578
Bill, when you can re-purpose a cash box into a battery box with counter pressed holes, you get credit for making it from scratch. Good work, for sure.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more