hitch reciever on box scraper

scotup362 · Nov 4, 2017

Would bolting this on to the back of my box scraper be a good or bad idea? My plan is to use it to move and spot my boat and other trailers.

bcp · Nov 4, 2017

Welcome to OTT.

That isn't a hitch receiver that an insert fits into. It IS an insert for mounting a pintle hook hitch. But, it could be bolted to a box blade, then a hole drilled in it for mounting a ball, and used to move trailers and crack shins.

Bruce

Lil Foot · Nov 5, 2017

I think bcp is right. Is this what you're looking for?
http://www.orangetractortalks.com/forums/showthread.php?t=15618&highlight=gannon+hitch
and this:
http://www.orangetractortalks.com/forums/showthread.php?t=30387&highlight=hitch+blade

scotup362 · Nov 5, 2017

Thanks for the welcome. I've got a lot to learn! Judging from photos only I thought that was a hitch receiver. Looks like the post from Lil Foot has another solution.
Thank you, Bruce

Lil Foot · Nov 5, 2017

I thought that was a hitch receiver.

Here's a couple pics of the adapter/mount shown in your first post.

Hfrs7 · Nov 29, 2017

I welded this receiver in my box blade. It uses a 2” drawbar that is held in place by a pin just like a receiver on a vehicle. Sorry this picture is prior to it being painted.....

AndyM · Nov 30, 2017

I was planning on building small carry-all when I came accross a hitch mount one for less than I could buy the material. Now I admit it's a little bit of overkill on a BX25 but it's easy on off and I can use it on the truck when needed.

Bjones · Dec 2, 2017

I just welded a piece of angle iron on back of my scrape box and installed a ball.

Search

hitch reciever on box scraper

scotup362

New member

Attachments

bcp

Active member

Lil Foot

Well-known member

scotup362

New member

Lil Foot

Well-known member

Attachments

Hfrs7

Member

Attachments

AndyM

Active member

Attachments

Bjones

Member