Hello,
I just bought a l1511 2cyl with hydro mission for slashing,everything works well but after 10 minutes it makes a whining noise then stops driving,allow it to sit for ten minutes and away it goes for about 100 feet then stops driving.
I have drained the oil,cleaned the strainers replaced the spin on and put fresh kubota grade oil back in and over filled it a couple of ltrs and it still does the same thing.
I've pulled the pump out of the box and stripped it hoping for a blockage but everything "looks" ok other the some wear on the plates which pull the pistons out of the barrels but their not bad enough to stop it working plus I think it's more a hydraulic issue.
Would anyone have an idea what would be causing this?
The pump modal is, daikin sundstrand 1515-602D,02-7-01508.
Also which other kubota modals use this type of transmission?
I just bought a l1511 2cyl with hydro mission for slashing,everything works well but after 10 minutes it makes a whining noise then stops driving,allow it to sit for ten minutes and away it goes for about 100 feet then stops driving.
I have drained the oil,cleaned the strainers replaced the spin on and put fresh kubota grade oil back in and over filled it a couple of ltrs and it still does the same thing.
I've pulled the pump out of the box and stripped it hoping for a blockage but everything "looks" ok other the some wear on the plates which pull the pistons out of the barrels but their not bad enough to stop it working plus I think it's more a hydraulic issue.
Would anyone have an idea what would be causing this?
The pump modal is, daikin sundstrand 1515-602D,02-7-01508.
Also which other kubota modals use this type of transmission?