joekimtkd
New member
Equipment
B7510DT, 4' Snow blower, 4' Loader, 6' Blade, 6' 3PH Finish mower, 6' box blade,
My B7510DT has 444 hours on it now.
While I was building cabin, I was going on and off on the tractor a million times but I never noticed.
Yesterday, I was hop onto tractor and I found slight movements of cabin. But it can't be. 'cause cabin is bolt it down tight to the frame of tractor.
So start shake them a bit and it still shakes and rocks.....
I got off and try to rock the tractor and guess what I found~?!
Rear wheel hub mount bolt was loose a bit. It still looked tight but I could see whole rear wheel and rear axle has too much play.....
I read shop manual and used torque wrench for 93 lb/ft.
and it says run minimum 200 yard to run and re-torque~, so I did too.
Yay~~~ Now I'm safe~~~!!! I think~!
So now I'm urging you to start rocking your tractor~!
Let's rock them~~
While I was building cabin, I was going on and off on the tractor a million times but I never noticed.
Yesterday, I was hop onto tractor and I found slight movements of cabin. But it can't be. 'cause cabin is bolt it down tight to the frame of tractor.
So start shake them a bit and it still shakes and rocks.....
I got off and try to rock the tractor and guess what I found~?!
Rear wheel hub mount bolt was loose a bit. It still looked tight but I could see whole rear wheel and rear axle has too much play.....
I read shop manual and used torque wrench for 93 lb/ft.
and it says run minimum 200 yard to run and re-torque~, so I did too.
Yay~~~ Now I'm safe~~~!!! I think~!
So now I'm urging you to start rocking your tractor~!
Let's rock them~~