Powering Fill-Rite pump

mdhughes

Well-known member
Lifetime Member

Equipment
L3901DT
Dec 10, 2014
1,207
622
113
Ste Geneveive county, MO
I just got a transfer tank to use to fill my L3901DT and wanted a easy way to power the pump on the tank. I got two Anderson SB-50 connectors and mount one of them under the dash on the tractor and put the other on the end of the power cord for the pump. I just need to come up with a fuse holder and some how to connect the wires to the battery.

Here is the connector under the dash with the dust cover on:


Connector with the dust cover removed:


Connector from the pump plugged in:


Connector on pump wire with the dust cover and a good view of the T-handle:


Wires needing to be connected to the battery:


Any ideas for connecting the wires to the battery?

And yes I bought the orange connectors to match the tractor.
 

Attachments

Daren Todd

Well-known member
Lifetime Member

Equipment
Massey Ferguson 1825E, Kubota Z121S, Box blade, Rotary Cutter
May 18, 2014
8,964
4,344
113
Vilonia, Arkansas
I like it. Nice clean and elegant :D I have three of those set up on my work truck for jump start stations. One front, rear, and on the control board for the generator/compressor. I like the plug and play idea :)
 

Dave_eng

Well-known member
Lifetime Member

Equipment
M7040, Nuffield 465
Oct 6, 2012
5,108
926
113
Williamstown Ontario Canada
Any ideas for connecting the wires to the battery?

If you make the connection at the starter solenoid rather than the battery, you will have a stud post which will likely accept another power wire.
The ground can go to wherever the battery ground cable connects to the tractor frame
 

mdhughes

Well-known member
Lifetime Member

Equipment
L3901DT
Dec 10, 2014
1,207
622
113
Ste Geneveive county, MO
I finished my wiring for the power connector, I used two ring terminals and a mini in-line fuse holder. I took the bolts out of the terminal clamps and put the ring connectors on the bolt side. I had to squash the ring a little to get them to fit.

 

Attachments

Last edited: