I have an L 3901 with loader and pallet forks its light in the rear i have loaded tires wondering if wheel weights would do it or should i go with a ballast box
Weight for Kubota L 3901
- Thread starter Jerry Montgomery
- Start date
Go with a ballast box to take some of the weight off the front axle. Something in the 1,000 pound range.
If you haven't already done so, you might want to set the rear wheel wider if you have R1's or look in to spacers if you have R4's.
If you haven't already done so, you might want to set the rear wheel wider if you have R1's or look in to spacers if you have R4's.
You should have something on the 3 pt when using the loader. You don't necessarily need to buy a ballast box if you have a heavy implement that would work.
I went with a 1000 lbs of wheel weights on mine. My tires are filled also. You won't go wrong with any method as far as I'm concerned. These tractors need weight in the back somewhere. You'll notice how much smoother the loader operates immediately, especially when lowering a full bucket, forks, etc.
Attachments
TripleR
Active member
Equipment
BX2200, BX2660, L5740 HSTC, M8540HDC and some other tractors and equipment
As mentioned, add weight to the 3PH for ballast and a bit of relief on the front axle. I have filled tires and wheel weights, but always put weight on the 3PH.
If you buy or build a decent 3pt carry-all, you can load it up with sand bags or an IBC or something similar to make a ballast weight, and get the added convenience of the use of a carry-all, instead of a zero use 3pt ballast box, and/or wheel weights.
I have an L 5740 with FEL and grapple,
How much weight is correct for a ballast box on this tractor?
thanx
How much weight is correct for a ballast box on this tractor?
thanx
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
You could use anywhere from 1000lbs to 2000lbs on that model, the more the better.
