B7500 Front Wheel Seal Question

BAP

Well-known member
Lifetime Member

Equipment
2012 Kubota 2920, 60MMM, FEL, BH65 48" Bush Hog, 60"Backblade, B2782B Snowblower
Dec 31, 2012
2,513
657
113
New Hampshire

BAP

Well-known member
Lifetime Member

Equipment
2012 Kubota 2920, 60MMM, FEL, BH65 48" Bush Hog, 60"Backblade, B2782B Snowblower
Dec 31, 2012
2,513
657
113
New Hampshire
Has anybody worked on of these?
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,306
4,856
113
Sandpoint, ID
The parts print is a little off, #60 is a clip that holds the case and bearings, you will remove that after you unbolt the case cover to get the axle out. Careful not to let the case gear (big ring gear) just fall out, as it might try and stick in the case when you pull the axle out. ;)
 

BAP

Well-known member
Lifetime Member

Equipment
2012 Kubota 2920, 60MMM, FEL, BH65 48" Bush Hog, 60"Backblade, B2782B Snowblower
Dec 31, 2012
2,513
657
113
New Hampshire
Thanks Wolfman, I wondered if there was a clip in there to hold everything in place.
 

Wbk

New member
Feb 20, 2013
307
0
0
St Adolphe Manitoba Canada
I have to replace a leaking front wheel seal on my father's B7500 4x4. How is the best way to go about it. Looking at the parts page, can I just unbolt the gear case cover and remove it? Is there something holding that shaft in? Or do I go about it differently. Thanks for any Help

http://kpadweb.kubota.co.jp/kpad2/PartsInfo.do?bookCd=100K0848&funcCd=&figNo=G12500&dispType=2
You might want to consider adding a vent to the front housing, my bx builds a lot of pressure and I've had to replace a couple seals on it. I had to modify my dipstick to make it vent.