Borrowed a neighbor's B7100. Used the back hoe and front loader to take out my driveway and load chunks into a dumpster. Apparently a pin holding the hinge for the BH bucket came out and the hinge separated on one side while under load. I only noticed when I saw the stainless rod part of the cylinder was bent. The bracket that holds the hinged part, shaped like an "H" is also twisted. I don't know the proper nomenclature, sorry. Don't have a manual either. Can I repair this by bending the rod and bracket, or do I need to find the two parts. I have found a back hoe only manual on-line. Thanks for any advice or info.