Hi guys, Im in the process of re ringing my B6000. I have a service manual, But I cant believe how crappy it is. gives no torque values at all, well for the head bolts it does but nothing more. does anyone know what the torque of the connecting rods should be? and what the clearances should be at the rod bearings? Thanks.
B6000 torque specs
- Thread starter jay87t
- Start date
Reviving this old thread for a couple of reasons:
1) The B6000 service manual does include torque values, as attached
2) Anybody know what units are used? There is no mention of this anywhere in the manual. Say, if it's in lb/inch, the torque for M12 7T bolts would be 66-77 lb/ft. This looks too high compared to other Kubotas torque on aluminum. Could anybody clarify / confirm this?
1) The B6000 service manual does include torque values, as attached
2) Anybody know what units are used? There is no mention of this anywhere in the manual. Say, if it's in lb/inch, the torque for M12 7T bolts would be 66-77 lb/ft. This looks too high compared to other Kubotas torque on aluminum. Could anybody clarify / confirm this?
Attachments
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Thanks again Wolfman!
That does help, so I can calculate the torque from the table and then subtract about 10 lb/ft.
That does help, so I can calculate the torque from the table and then subtract about 10 lb/ft.