On my Kubota L35 I took the loader control valve body apart trying to diagnose a problem that turned out to be unrelated. At the bottom of the valve there is a cylindrical cup over the bottom of the spool. I pulled this off the bottom of the spool and out popped a bearing and a spring. The bearing had compressed the spring into the bottom of the spool and the bearing was heald in place by four other bearings, that in turn are held in place by the cylindrical cup.
The problem is putting it back together. surely there must be a trick to this.
Alternatively, do I need it there? I can't figure it's purpose
The problem is putting it back together. surely there must be a trick to this.
Alternatively, do I need it there? I can't figure it's purpose