Loader Pins

SidecarFlip · Mar 7, 2019

DustyRusty said:
I used to use PB Blaster as my penetrating oil of choice, until I tried a can of Deep Creep by Seafoam. It is more expensive than PB Blaster, but it works much better. Give it a try, and you will never use anything else in the future.

I mix 1/3 ATF with 2/3 acetone in a squirt bottle, beats them all.

russell.still.5 · Mar 7, 2019

AllDodge said:
Well my port a power is only 4 ton so it didn't do much of anything.

Took some oak blocks, a chain, binder and 20 tom jack, and it didn't budget it either.

To get to that one,with the reciprocating saw, I disconnected the curl cylinders and just let the SSQA hang there. It was tight but I was able to get the blade in there.

Sent from my iPhone using Tapatalk

AllDodge · Mar 7, 2019

I'm sure I can get it cut, the issue is how to get the piece out after cutting. If I have nothing which can press it out now, after cutting isn't going to make it any better.

Just trying to figure best option before I think of cutting

russell.still.5 · Mar 7, 2019

AllDodge said:
I'm sure I can get it cut, the issue is how to get the piece out after cutting. If I have nothing which can press it out now, after cutting isn't going to make it any better.

Just trying to figure best option before I think of cutting

I think I ended up drilling a hole all the way through the pin and used pipe and all thread along with some heat to get it moving. Once it moved it came on out.

Sent from my iPhone using Tapatalk

AllDodge · Mar 9, 2019

Git it out, cut off, used 2 jar puller, heat and hammer.

GeoHorn · Mar 10, 2019

Good adaptation!

russell.still.5 · Mar 12, 2019

Glad you got it fixed!

Sent from my iPhone using Tapatalk

Search

Loader Pins

SidecarFlip

Banned

russell.still.5

New member

AllDodge

Member

russell.still.5

New member

AllDodge

Member

Attachments

GeoHorn

Well-known member

russell.still.5

New member