Search results

I went ahead and changed the fluid and filters, it was probably a waste of money but now I know it's correct. I haven't used it in a few weeks but plan to move some snow piles with it tomorrow.

That's what I was thinking since the fluid is so new, thanks for the advice, I appreciate the help. This could be a messy one, I can just see me dropping the drain plug down my sleeve or something......LOL.

I just picked up a used B2710 with 550 hours on it, the fluids were all done 40 hours ago and the trany oil level is about 2 inches above the full mark, is it a problem to run it over full? My workshop manual is in the mail. Thanks Vince

Please delete Ordered a new one, thanks. Thanks Vince

Thanks very much for the info and tips.......I appreciate it!!

Thanks very much for the help!! Do you think I can pull those caps in place or would it be better to put the valve on the bench to do it? Spent some time with the little machine today swapping out fluids and giving it a once over, then worked the road for an hour and am really impressed with...

Butch, Any tips on re-building that control valve? Thanks Vince

Thanks for the reply! I played with it a little more today [looking to buy] and it's not as bad as I described, the dead spot is closer to the end of the stick travel. I will try your suggestions when I get it here. May need a radiator, if so I will contact your dealership.

I am new to the forum and have a question about a Kubota loader that is on a B2710, it works fine for lowering and bucket dump but when raising the bucket if you pull the stick past halfway it stops. You have to feather the bucket up using about half of the joystick travel. Anyone seen this or...