Search results

Looking for some advice, see below video. When following the proper procedure for removing the FEL on my 2023 LX2610 with 35 hours i am only able to easily remove the left pin. The right pin will rotate but requires a lot of force. I am on a level surface in my garage. I noticed if i put a 2x4...

Shaft length seems perfectly fine. With the hitch all the way up there is still about 1.5 inches before bottoming out. I can almost remove the shaft from the tractor with it fully raised. I think the angle is the issue. And yes, I don’t need to raise it that high but it is much easier to not...

Good points. That does make sense. SB1064 Manual says not to exceed 25deg it seems like I am within that limit but still having that issue. Maybe I need to break the protractor out, lol. Thank you for the insight!

Hello, I have an issue on my SB10 blower I can’t seem to diagnose. Snowblower operates normally unless it is raised to above “7” on my 3-point control lever. Around 7 there is a loud rattle from potentially the gear box or auger. If the hitch is lifted any higher it will shear the PTO shaft...