Search results

I have a new to me L3710 that the hazard lights don’t work on. I can turn them on and the dash lights flash, but the back light don’t. I checked the bulbs and they work. I can turn in the headlights and they back lights come on. I’m looking for ideas of where I should start looking. Bob

I’m going to be putting up a shop sometime this year. I’ve been looking at steel buildings, but I noticed that a lot of them use 14 gauge tubing for the frame. My question is the 14 gauge frame sufficient for the structure? Bob

I read in the forum that Kubota tractors have a built in over run clutch. Is that true? I have a L3710 GST. Bob

I changed the transmission and filter on my new to me L3710 GST. I miss read the amount 10.3 gallons as 12 gallons. Is it OK to leave it all in there or should I drain out the extra? Bob

On the B7100’s I ran in the 80’s you turned the key counter-clockwise for the glow plugs. On the L3710 do you just turn the key counterclockwise one click for the glow plugs. The glow plug light comes on but just for about 10 seconds. Is this normal? Bob

Just picked up a L3710 GST, haven't been around a tractor with a GST before. To me the pause between shifts after moving the gear shift seems to be too long to me. Is there some way to adjust the transmission to shorten the time between shifts? If I throttle back as I shift there is no...

Kubota tractors are new to me, just purchased a used L3710 this last week. I’m assuming the dipstick is the little rubber knob lower on the drivers side of the engine. Do you just twist and pull it out? Don’t want to wreck it. can someone recommend some good YouTube videos on maintenance...

I just bought a used L3710 GST. Don’t have a owner manual and can’t find one. Can someone tell me how to operate the PTO. I’ve mostly dealt with John Deere tractors. Bob

I recently bought a Kubota L3710 GST tractor. I want to change all the fluids so I know their clean. What is everyone running in their GST transmissions? Bob

I recently bought a Kubota L3710 tractor with a SMC Schutz 2409 Division Loader at auction. The loader didnt come with a bucket. I have a bucket that I am going to use. I’m looking for input on where to place the loader pivot points for the loader arms and tilt cylinders. Also how far apart...

I recently bought a Kabota L3710 GST with 1400 hours on it. Where can I find fluid/capacity specs for it. Are service manuals available for it? Thanks, Bob

I’m looking at a Kabota L3710 GST with a backhoe on auction. Tractor runs good, but I’ve never been around a GST tractor before. I drove it around and when shifting to a higher hear it would pause momentarily then start moving. Is this normal? Tractor has 1450 hours on it. Thanks, Bob