Search results

My tractor is Kubota L2900 with I think has D1503 engine.what size glow plug and fuel injector thread pitch size adapters does it have to have?

It was knocking so I tryed different injectors.it didn't help the knock and smoked.so I put the old injectors back in.engine never did smoke with them.now it does really bad.after putting them back.

It didn't do that with the injectors in it.now blue smoking alot and didn't fix the knocking.only thing I noticed different is motor not pinging.

Have a Kubota L2900 tractor.do you have to remove the head to replace what I call lifters

What all wrench sizes needed to remove the injectors on Kubota L2900.

My L2900 recommends a 2-12" plow or 1-16" plow.my tractor has the 420/70-24 rear tires.what all plow moldbord sizes would work for tire size? Do tire widths determine for what size plows for furrows?

When you remove loader from l2900.after unhooking hoses is there a shut off to keep from sending fluids?

On mine only lights that come on is battarie and oil preasure.and one Hazzard light.how many lights should there be and how many bulbs would I need if replacing them.

Anyone have crossreference bulb numbers to replace the factory oem bulbs?need several dash ones and others.

On the fuel injectors do new ones not come with washer and heat shield number3 and 4 ? If not can you use old ones.

Anyone have a copy of operators manual for Kubota LA480 loader?

How wide is the Kubota rims for these? Would a 12.4 tire fit on same rims.

The tractor has piston slap or worn wrist pin.should I pull the pistons and rods and put new ones in it? Or just run it like it is until have to do a complete rebuild on it? Whats your all opinions.runs fairly ok know just has a knock.only has a little blue smoke when you first start it up cold.

Anyone know what this knock is?

I know this is a silly question.i just purchased a Kubota L2900 tractor.how do use the glow plugs.is there a button you have to push to activate them.

On my Kubota L2900 the tachometer needle is way below zero.it works but can't be accurate.is there anyway to set the needle to zero rpms.

So I got my tractor and was looking it over.and I noticed my loader doesn't have the stands or a place where they fasten.or the quick hydraulic connectors.iv been watching videos on how to remove a lot of them.showed lowering stands then unfastening the hoses.i guess this loader isn't one of the...

Anyone have an operates manual.to figure out where everything is.

Has anyone rebuild there engine using China made cranshaft,connecting rods,piston and heads?if so are they good? My first thought I figured they wasn't any good.then iv been reading where the eagle and scat crankshaft was made in China I always thought these car parts was made in U.S.A.they were...

Does anyone have a copy of the procedure to remove the engine.and a copy of engine overhaul procedures and torque specs?