Search results

Took it to the machine shop, they used a torch to cut a relief and pounded it out. Funny thing is , there wasnt any sign other no grease. They told me it was friction welded.

I had to re-read your reply. There are washers there. I have new ones . I could try that way as well great idea

I thought of this too, but I didnt have any.

I drilled a 1/2 hole down the center of the pin and all the way through. I thougjt the same thing with using a metal blade and a sawzall. I dont have a large enough drill bit to finish drilling out to accommodate the blade. So I am ordering one. I think if I cut it in two places, it should...

So tue bottom pin is welded in place. I removed the hoe extend arm and then the attachement. I tried pilot drilling the pin, put a torch to it too heat it up and the pin still wont budge.

Sound like it ! I ordered new pins,just waiting for them to com in. I asked the service department about it and of course, they never heard of such thing. 😆. Getting out is going to be a chore.

My hoe will not swing left and i have check both swing check valves. I removed the swing cylinder pin that attaches to the swing frame and I can watch the cylinder operate in both directions. I tried to manually push the hoe left and right, but can't. I even tried to use a large tree as a...