Search results

My l345 double clutch action does work either.the manual list single and double clutch for the l345... I either start it engaged or pull the the gas cut off as you do to shut it off and just before it dies pop in the PTO then release the cut off.not an expert on these just own one. Possible its...

Pto shaft not bound,knob under seat makes no difference..Any other suggestions? i see another newer post on a L series that doesnt operate..by looking at this the pump for the power steering also connected to the pto. the power steering does work.is this its only power source for the pto or...

Thanks for the replies, i never used that knob but i did turn it both ways.i will have to relook at the pto shaat . before i received you post i put a jack under it and raised it to see if something would release. I was expectingsomething in the gear box . i will relook at that tommorrow if its...

L345.. lifted 3 point up with mower on it , will not go down. left it like that all night normally will bleed down.the levers for the lift move all the way up and down.there is a linkage from the top arm under the seat that appears to be the feedback sensor that connects into the three point...

L345.. lifted 3 point up with mower on it , will not go down. left it like that all night normally will bleed down.the levers for the lift move all the way up and down.there is a linkage from the top arm under the seat that appears to be the feedback sensor that connects into the three point...

Has anyone ever added a cooler for the trans/diff oil ? when I run it for a long time oil come out around the gearshift..maybe because its gets thinner as it gets hot and is more likely to be slashed out.

www.surpluscenter.com has a new motor but I don't know what it fits maybe others do

Thanks for the reply. I have the parts manual but not the service manual.. When removing the top is there anything to watch out for? Should I remove the top plate with the shifter only 1st or just remove the entire top plate? thanks Doug

My L345 started making a clunking/knocking sound . the noise goes away when I have the clutch pedal depressed. So in neutral or in gear makes the noise. Maybe something with the input shaft of the transmission. I removed the inspection plate for the clutch area but didn't see anything there.I...