Search results

Any ideas for a u-joint that will not take grease? Zerk off the joint accepts grease with no issues, but on the joint, the grease just comes right back out the front of the zerk...nothing getting into the joint. I saw on a few threads to try heat- propane torch did seem to loosen some old...

Question mark in subject because I'm not really sure I'm talking about a loader pin (pic below of what I am referring to) as I am relative noob...about 80 hours on my B2650- mostly cutting field with rotary cutter and moving piles of brush with SSQA pallet forks I noticed after cutting today...

Manual doesn't call for transmission fluid change until 400 hours, but Kubota's website says to change it at 50 hours (with caveat that the instructions are generic and to refer to your manual) https://www.kubotausa.com/service-support/maintenance-schedules/check-points-maintenance-schedule...

Got a Lock N Lube over the winter and tried it out- works great for greasing everything except the bottom zerk on the SSQA lever- too tight of a space for the LNL. Does anyone know the size of this zerk? I'm thinking about switching it out for 90 degree zerk. Relative noob so not sure if...

Hey all. Colder nights snuck up on our area a little early this year and my B2650 is the only piece of diesel equipment I've ever owned, so I wasn't really thinking about the impacts on the tractor. I didn't get any fuel treatment added and it's been down to about 15F or so a couple of nights...

Hey all...very noob tractor owner here. Dealer dropped off my B2650 with Rotary Cutter attached after mentioning at the dealer during their educational walk-around after we purchased that it was ready to use. I mowed about 4 acres of level ground with no ditches or anything and then parked the...