Search results

Got it fixed. It was a diiiirrrtttyy transmission filter.. loke, really, really dirty. Made me shiver a little bit.

That is correct, only, I have not seen anything coming from the vent hose. Actually, I didnt notice the vent hose. I haven't had a chance to clean the filter yet, nor have I looked again since Wednesday evening, I had class Thursday evening and Tonight I worked a little late and prepared for...

I am confident about the source of the leak. I cleaned up the rear of the tractor before my post earlier, I started the tractor and operated the 3 point and watched it leak from the area I mentioned earlier. I've been looking at parts diagrams from coleman equipment and I think it is leaking...

Ok, so I took a look... The leak is coming from the seal just below the lift arms that is covered by the top link plate. However, I dont think that is what is causing it stop working. I started the tractor and it will lift and lower several times. Each time it will get slowet until it stops...

Ok, I'll try that first.

Hey e'erybody, I am about to attempt to replace the seals on my b6000 (New to me on the 7th of this month). I tested the 3 point when I got it and it worked fine. I even tried it with my fat but standing on the lift arms. Saturday I picked up a 48" blade and put it on and used it for a few...

Meh, I was hopeful.... I knew the engine turned in reverse, but wasnt sure if there was an additional gear in the 6100, but now that I actually th8nk about it, regardless it would do the same thing... Oh well. I guess a reverser is the way to go then.

Hey Rob, read your other post and can't find a 7001. However, there is a 6100 nearby that I can pick through. So, just to ensure I read your message correctly, I need the rearend/gearbox assembly? I honestly dont have a need for the PTO now, but I think I can get the parts super cheap. Thanks...

I knew about the pto, it's a ccw and 10 spline. The attachments I need or want currently don't use the PTO so, It wasn't as big of a concern for me. I will keep an eye put for a reverser. IF I find one I'll buy it, but for now, I'm happy with not using it.

Hey guys, Just picked up a b6000, it is mostly restored aside from some minor paint issues and the guy I purchased it did something weird with the wiring and the glow plug and ignition. I paid 1600 for it with no implements, but it runs fantastic and the paint job is pretty good for a spray...