Search results

Hi again guys....so loader and 3pth have gotten weak quickly. Did an oil and filter change but didn't help. FEL will barely lift grapple bucket at 2000 rpm. 3 pth so weak that it won't lift the hitch off the ground on a bale processor. Is the only logical explanation the pump?? Or is there...

Hi again guys, I'm having some fuel/power issues with an M135X that I'm unable to diagnose. Getting an engine warning light but no visible codes. I'm wondering where I could find a code reader for this machine? And which one I need? Thanks! Sent from my XP7700 using Tapatalk

Having some issues with eradic idling, insufficient power. Took electric fuel pump and water separator apart. Fuel pump had a lot of rust particles on magnet. Cleaned. Blew out lines. Ran good for a week then started again. Repeated process. Running good again. Now going to rinse tank as...

Hi guys, got an m135x that is hell to start when temps drop below minus 15 Celsius. Block heater is working fine. No glow plug indicator light coming on. Try to force glow plugs by shifting into gear and holding key in start position and still doesn't help. Just wondering if there is a glow plug...

Hi guys, having some overheating issues with 135 when baling. It typically runs hotter than 120 and 125 models but after running at 2000 rpm on baler for only 2 bales it runs up to red zone. Cleaned all rads, coolant good, fan is running, air cleaner etc good. Any suggestions on what's next...

Hi again guys, This time problem with 125. Started fine this morning and ran for a few minutes then just quit suddenly. No signs of gelling. cranks over really well, but clearly no fuel. Water separator full, filter full, tank full. Tried manual primer valve but no luck. Any suggestions? Thanks!

Hi all, any suggestions as to what may cause PTO to not engage? Fuse good, infact, the dash display shows that PTO is on, however it won't turn. Thanks!

Hi folks, just signed up this evening. I have an M125 with stripped splines on the front differential pinion gear that joins to the front propeller shaft. Got the new parts and removed the front axel from the tractor. Got the bolts out of the pinion bearing case, however the pinion bearing...