Search results

Wife ran into a stump and bent the king pin metal bar piece that looks like a 2 x 6 steel rectangular bar. Wheels are now facing in opposite directions when trying to steer. Can this rectangle by bent back straight in order to re-use? New part is expensive. Tie rod is also bent but going to...

PTO belt snapped. Replaced with aftermarket but the belt keeps slipping off deck spindle. Is belt size incorrect? Tension spring shot? Something I'm missing? Also there is a lot of grease/on pto spindle area..seems to be leaking. is hydro fluid supposed to be replaced in PTO and how to get to it?

Is there a common auto radiator cap replacement for the OEM one? Cheapest is $30 that I see on ebay.

Disconnected ignition switch from harness. Measured voltage from red wire on harness side to neg battery terminal and get no voltage. Is there anything that can interupt the connection?

Takes about 10-20 sec of turning key and holding before I finally get ignition to occur. Engines turns over fine just will not start immediately. My glow light does not come on when engine key is turned on so wondering if glow plugs are working? Any other suggestions to check?

My glow plug light on dash no longer comes on and starter takes forever to get engine to start. Seems like no power to glow plugs. What is the relay or module that controls power to glow plugs. I don't really see anything on the electrical diagram

the pdf I posted is a view from the left front of the tractor... the tensioner rides on the left side, in the little bend in the belt just back of where the line from 150 points to. to get the tensioner over there, make sure you disengage the tensioner link that hooks on the bracket just inside...