Search results

Yes I did the stupid , I put my battery charger on my tractor with the switch on and when the switch went past the 12amp charging spot to the 75 amp cranking the voltage smoked my voltage regular . I turned the switch off but not soon enough. I charged the battery and loaded the tractor and went...

My rebuilt B6100E has a 18lbs oil pressure ? . the engine was completely rebuilt. She runs great with no rattling so I thought it may be the Light not working properly , During the rebuild I rewired the tractor completely with new oil sending switch also ? . The manual shows an oil pressure...

On a Kubota engine how do you remove a cylinder lining out of the motor block, I was told they are dry linings ? . the # two piston hole is worn 10 thousands over , TOO much to run right if at all. It is using oil. the other two pistons hole linings are within 1 1/2 thousandth over so they will...

Need B6100e Cylinder Head, Mines Cracked big time, no repair in the question. GT

Can I remove the oil pan & head and install bearings and rings without pulling the engine ? . I have the b6100e on motor stands reworking everything except the motor, tyranny and hydraulics at this time. the baby is naked the motor smokes a little and the exhaust pipe is black and oily. I have...

OK I'm in the process of reworking the B6100E from the running gear out so I'm going to need stuff, should I go to my local dealer or will someone here may have some of the items I need. to start with both wiring harnesses the main one and the smaller hook-up one under the dash needs replacing...

OK I'm in the process of reworking the B6100E from the running gear out so I'm going to need stuff, should Ii go to my local dealer or will someone here may have some of the items I may need. to start with both wiring harnesses the main one and the smaller hook-up one under the dash needs...

Kubota paint $38 bucks quart @ Dealer Farm Equipment Valspar Enamel $38 bucks a gallon @ Tractor Supply has anyone tried , TS paint. Or is the dealer paint that much better. GT

I need a Bonnet/Hood for my B6100E, the one I have has several issues from battery acid damage to rust, no dents though, I am doing a visual rebuild (paint job, new wiring, clamps, hoses & etc.), if it can be seen it's getting attention. The idea of laying down 600 bucks for a new hood ant...

I am redoing my B6100E, I am stripping everything off leaving the motor and tyranny with rear end in tack. while painting and rewiring the gal. I was thinking should I install oil pressure Gage where the hour meter is or replace the hour meter and leave the light as factory installed. GT

New here so don't beat me up. Ok , I had a little 550 oliver tractor several years ago, after selling it it took me twenty years to get another tractor. Yesterday while over at a friends house , there it was, not in a box like a little kitten waiting to go home with me but a little Orange...