Search results

Hi, My F1900 has lost drive to the PTO. The lift arms work ok and it drives ok, but engaging PTO lever doesn't cause deck to spin. I've followed the PTO lever to the transmission and the linkage appears to be operating ok. I've checked the PTO fluid level, it was low, so I've topped it up using...

Wanted to buy, beg, borrow. Workshop manual for Kubota M5500 please. I'm in New Zealand on the other side of the world, so would prefer to get my hands on a digital file if possible. Otherwise, happy with a lump of posted paper. cheers Shane

I have a B2150 with turf tyres fitted and the drive shaft to the front axle removed, so it's running in 2WD only. I want to get it working in 4WD and fit R1 tyres on all four corners. The workshop manual I have makes several different suggestions as to tyre sizes and it's not something I want...

I've just bought a 4WD F1900 with no deck. Now I've found an after market deck (model TMB60RH) but don't know which model Kubota it came off. Looking at the photos of the deck it looks like the hydraulic arms are wider apart than those on the F1900. But I thought these were all just standard...

I have a B2150 with turf tyres on the rear. The tractor sits too low to the ground so I'd like to lift it up a bit. I assume I could achieve this by putting original sized wheels & ag tyres on, but having a bit of trouble working out the correct size. Tractor currently has 275/70R16 tyres on...

The rear linkage on my B2150 HST has started going up and down by itself. It's happening by itself. The control lever is set to down. Have we bumped another control or is this a fault ? Tractor is running at idle in the video, but fault still occurs at 3/4 throttle. Fault occurs when HST is in...

The instrument cluster on my B2150 HST is stuffed. Looks like the tractor has lived outside most of it's life. Is anyone dismantling a B2150 (or equivalent) and want to sell the complete instrument cluster and is willing to post it to New Zealand ? Thanks Shane

My B7000 has only a hand throttle. The throttle won't stay in the position it's set to, instead it reverts back to idle if I let it go. The throttle lever pivots on a fixed rod with a washer and split pin holding it in place, so I can't adjust the tension at this point unless I add a fibrous...

I've just bought a B2150 HST. It's scruffy but seems to be in good running order. I also have an International B47 baler, normally pulled by my 40HP International 434. Does anyone here have any experience pulling a conventional hay baler behind a B2150 ? It would be a flat paddock, no hills...

I've just bought a Kubota B7000. The previous owner had it for ten years and only ever pulled a trailer around their flat land. The tractor was never put under any load. I hooked it up to a tedder yesterday and gave it 3/4 throttle to get everything up to speed and the tractor emits quite a lot...