Go Back   OrangeTractorTalks - Everything Kubota > Search Forums


Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: North Idaho Wolfman
Forum: Service, Repair & Maintenance 45 Minutes Ago
Replies: 3
Views: 90
Re: B6200 injector questions

You need to get new / rebuilt injectors from a source like Oregon Fuel Injection, they will already be tested and set for the proper pop off pressure.
I also recommend that you replace all three at...
Forum: Off Topic 48 Minutes Ago
Replies: 3
Views: 141
Re: Help me figure this one out....please!

It's been doctored, watch the gaps and the size of the tile squares, they don't look the same from one to the other.
When he swaps them around they never end up being perfect squares, then magically...
Forum: Service, Repair & Maintenance 1 Hour Ago
Replies: 7
Views: 144
Re: Finding My Tractor's Total Weight

A second for the 10K or better trailer, and make sure it has electric brakes on both axles.
Forum: Service, Repair & Maintenance 1 Hour Ago
Replies: 11
Views: 503
Re: Omg,what went wrong,filter ruptured

You have it hooked up right, because if it wasn't either the three point or the FEL wouldn't work.
The three point relies on the PB being set to it, and the IN and Tank on the valve for the FEL...
Forum: Tractor Operating 1 Hour Ago
Replies: 8
Views: 7,152
Re: No dang down pressure.

On most Kubota's especially the small models, you can not make the 3 point have down force in it's stock form, the three point connection to the piston is not attached, thus no down force, no matter...
Forum: Service, Repair & Maintenance 23 Hours Ago
Replies: 2
Views: 95
Re: L35 hydraulic leak

You need to get the WSM for all the work on your tractor.

There is no free or cheap download.

You can get it here or a local dealer....
Forum: Service, Repair & Maintenance 23 Hours Ago
Replies: 3
Views: 90
Re: B6200 injector questions

1: Where was it leaking, there are four places it could be leaking, at the head, in the middle of the body, at the top of the body, and at the Fuel line.

2: It's just press fitted on the shaft...
Forum: Service, Repair & Maintenance 23 Hours Ago
Replies: 11
Views: 503
Re: Omg,what went wrong,filter ruptured

Did the three point work?
If it did, then the loader valve is correct.
You really cant pressurize the HST from the hydraulic system.
The line out of the top of the HST is an low pressure / suction...
Forum: Service, Repair & Maintenance 23 Hours Ago
Replies: 2
Views: 97
Re: g4200 h run away after injection pump rebuild

Other options:
If you pulled the pumps did you realign them?
Do you get the rack back in the proper place to engage the governor assembly?
Forum: Service, Repair & Maintenance 23 Hours Ago
Replies: 1
Views: 76
Re: B7100D gear, I donít think itís the throw out bearing

A lot of times the noise is from a worn joint and connection that leads from the engine to the HST unit.
Check that joint for wear and or slop.
Forum: Implements & Attachments 23 Hours Ago
Replies: 5
Views: 482
Re: Does anyone own the Lane Shark cutter??...

Read up on it as it's designed for cutting ditches! ;)
Forum: Service, Repair & Maintenance 23 Hours Ago
Replies: 10
Views: 345
Re: Online Parts?

I'm in the same general area as winesalot.
An hour long drive up in Our parts can get pretty hairy in the winter!
The local dealerships up here are way less than competitive and very un-inviting....
Forum: Implements & Attachments 2 Days Ago
Replies: 6
Views: 166
Re: pallet fork compatability?

If you have an SSQA mount and the forks are SSQA then it will work.
Forum: Service, Repair & Maintenance 3 Days Ago
Replies: 1
Views: 46
Re: B1750 clutch

It's a dry bearing, you can use a little grease to put it in but it does not get greased, the plastic lining is Teflon that is used to lube the shaft.
Forum: Service, Repair & Maintenance 3 Days Ago
Replies: 3
Views: 88
Re: Racor 120AP vent plug replacement

Just go to a local Auto parts store and get a 3/8 to 1/4" barb to barb fitting.

Does racor spell out 3/8" 24-unf threaded fitting?
That's a very odd fitting size.
Forum: Service, Repair & Maintenance 1 Week Ago
Replies: 5
Views: 201
Re: Tachometer pegging gauge now

Pull the drive portion on the front of the engine and check for smooth operation.
If that side is good then it's most likely a bad / worn out Tach.
Forum: Service, Repair & Maintenance 1 Week Ago
Replies: 5
Views: 252
Re: b2910 fuel line, is it important?

It connects to the vent on the Racor. ;)
Forum: Implements & Attachments 1 Week Ago
Replies: 4
Views: 118
Re: old L2250

Is it a 2wd or 4wd?
What tires does it have on it?

The simple answer is yes, now is it's going to be a good fit is the more complicated answer. ;)
Forum: Service, Repair & Maintenance 1 Week Ago
Replies: 18
Views: 832
Re: Biofuel Blues

Dump the sludge and add biocide and fuel treatment and new fuel. ;)
Forum: Service, Repair & Maintenance 1 Week Ago
Replies: 13
Views: 888
Re: Uh oh

STOP and Drain it out!
You put in 190 times as much as you should have! :eek:
Emissions controlled tractors can be damaged by excessive use of additives, I'm sure you don't want to have to replace...
Forum: Gray Market & Zennoh 1 Week Ago
Replies: 6
Views: 188
Re: servicing grey tractor parts

It happens to all of us, these suckers can be confusing.
Forum: Service, Repair & Maintenance 1 Week Ago
Replies: 10
Views: 1,777
Re: b7800 wont crank

Yes on the side of the bell housing is the switch, 2 nuts move it up and down.
Forum: Off Topic 1 Week Ago
Replies: 39
Views: 1,035
Re: Hows your deer season?

It's been great :)... Haven't hit one with the truck yet this year! :p
They are as thick as flys on poo up here! :D
We always have a couple on the property, and I think I see at least one a day hit...
Forum: Implements & Attachments 1 Week Ago
Replies: 6
Views: 141
Re: Install L2052 on L3710

The mount is a L2054B
You can see all of it and get part #'s here, click on view illustrated parts, then on agree, and then put in the model #.
http://kubota.com/part/partsList.aspx
;)
Forum: Implements & Attachments 1 Week Ago
Replies: 1
Views: 104
Re: L285

Sent you an email with the L285 WSM link. ;)
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 11:07 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.