Recent content by Sawzall

Ok fellas that definately helped and everything is working in the correct order but.....The loader lift has very little power. 3 point is strong and curl is strong. I have to really up the rpm's to get it to lift past halfway and it will go all the way up. I can shut it off and lift will stay up...

Wolfman can we go back to the hydraulic block diagram for a minute? I've attached the loader with a new valve. Not exact confirmation but with same features. And I have turned the selector screw. It's doing some weird things. Bucket curl and steering works fine but loader lift and 3 point won't...

Ok that makes sense on the multiple fill points.

One more question, so the transmission and rear filler port share the same fluid and sight glass? What’s reason for 2 fill ports? I’m old school fords and masseys. 1 fill port on transmission only.

IT WORKS! Thanks so much. Other than it blew out the other side steering cylinder seal.. I knew I should have replaced both. But after doing one side it's actually pretty quick and simple. Now we'll get into the other stuff that's getting ready to pop once I put it to work.

This is some awesome info. Thank's, I'll get into this after work

Selector switch? Hydraulic block? Sorry but this is my first Kubota and learning what makes what happen. No stickers remaining and any instructions or identification on any knobs are long wore off. The only blocks I'm aware of are the block where I disconnected the loader hoses to remove the...

I looked at parts blowup on Messicks website. It looks like the shaft seal at the 2 bolt flange on the pump. Part #31381-76390? Thanks a lot I would of never figured that out.

Well all right then. Went out and looks pretty straight forward. Is the anything particular I should watch out for so I do it right the first time?

Hi there. So I have this L3450DT-7 tractor I've been tinkering with for a year or so and finally have it ready to take home and start using. It had some really bad hydraulic leaks originally when I got it and those are now fixed. Yesterday I added a gallon of hydraulic oil at the fill port...

That way I can just use a standard valve for the loader

Hi new here, I have a L3450 with Woods dual loader. The loader valve is shot on the up/down spool. I’ve determined this is a “power beyond” valve with a supply and return hose from a block on side of tractor to valve as well as a third hose from valve returning to a third port on the block...