Recent content by Rustbucket78

Thanks alot for clearing that up for me.

Was wandering if this procedure for setting valve clearence on the d905 will work for the d950?

i have quick question,i just rebuild my d950 completely, whats the best procedure for first time start up and should i use a break in oil ?

Thanks, already had all the manuals couldn't find it in any of them,but I figured it out, it can only go one way lol now all I need is the torque spec for the pressure plate to flywheel, they're #7 grade bolts i believe, so I'm assuming 10to12 ft.pounds.

looking for help, i didnt pay attention to the clutch when removed can anyone tell me which direction the clutch plate goes back in . i noticed one side sticks out farther than the other side its a hydrostat not a manual shift. thanks

Yes was planning on machine shop to do it, but if the price is that high then I'll just buy new head,thanks all.

Hi everyone have been reading alot of good advice on here,I have a question does anyone know where to buy some valve seats for a b7200 d950 cylinder head I've looked everywhere finding some but don't know how reliable the source is,any info would be greatly appreciated.

I'm not trying to throw anyone under the bus or anything like that but I've read it on this site,there was even pictures posted showing all the specs, so I was going by that but I downloaded some wsm digital books and they say different I dont know what to go by thats why I was asking. Even the...

I have a question I hope someone can clear up, I have a b7200 with a d950lah engine I'm rebuilding, trying to find the correct ring gap has me concerned as I've found that everyone says it starts at 00.17mm up to 32mm but a book I downloaded says different it says .30to.45mm ill try and put the...

Thanks

Very nice! Thanks. What would be the best engine assembly lube for the rebuild?

Anyone know where to get a clutch alignment tool for b7200hste?

Thanks wolfman, would a regular ol manual hydraulic press work? If so what would be the technique? I know ill have to take it and have it bored just trying to do as much as possible myself. Would also like to say thanks to you and this site without it I'd still be scratching my head.