Recent content by RockPileGardener

I have a GCK60-26BX which is attached to my RCK54P-23BX, all on my BX2380. It works pretty good but there is one problem I have not figured out. While mowing there can be considerable leaf and grass clipping coming out from under the right front corner of the mower deck. I usually have the deck...

I bought a Heavy Duty 3 Point 2" Receiver from Tulga Fifth Wheel. I takes the same ball that I use with my truck. I also bought a ripper that mounts in the 2" receiver. Additionally the 3 point hitch receiver has a nice loop that I use to pull up small trees with a chain. Having all these work...

Interesting chart on HeavyHitch. According to the pin size, my BX2380 has a Cat 1 3 point hitch. I'm sure there's more to it than that, but it looks like the pins aren't the defining feature of 3 point hitches. I'm going to return the TSC subsoiler but not sure which route to take. I was...

Chim, I don't plan on doing a lot of heavy duty work with it. I'm mainly looking to cut through roots and loosen rocks near the surface. There are a lot of 2-4" saplings I need to clear and I hope to cut the roots and loosen the soil so I can clear them out. I'm also trying out a Piranha bar...

Guys, thanks for the replies. I didn't realize there were different sizes available, this was the only one they showed. Now the question is, since it "fits", do I keep it or try to find a smaller one. The middle buster might be the right way to go. It's shorter and looks to be just as beefy. I...

I'm getting ready to start converting a wooded area to lawn and garden and have been reading about the right combination of implements to use with my BX2380. I've settled on a Piranha bar and a TSC CountyLine subsoiler. The bar is on order but I was able to pick up the subsoiler at my local TSC...

One more point about the FEL. You can change it out quickly so long as you have a flat surface to work on. I have to remove mine in a shed that's not quite deep enough and the rear tires are a little lower than the front. Makes the changeover a little challenging. But if you can do it on a flat...