Recent content by mdj577

Same with my BX22. Any updates/progress on this?

Wolfman- Seems good on the battery end. Will check in the ignition side. Thanks for the reply.

Mid 80's B8200 HST, 600hrs. Owned tractor for 5yrs without any problems. Few days ago I turned the key counter clock to warm glow plug but no current seemed to flow to the coil on the dash. Turning clock wise did not cause the starter to turn either. When I repeated this sequence the coil did...

Thanks eserv. Found a really nice 9200 cheap. Though looks as if it has no mid pto (or rear or 3point or rops for that matter). Still tempted though as it appears to be in phenomenal condition. Struggling over if it is worth getting and adding functionality later.

May sound like a dumb questions to those with experience: Did all B-series tractors come with mid PTO's from factory?

Just picked up a loader for my B8200. Not sure how to hook up hydro lines to distribution box. Loader control consists of 2 levers (up/dn and dump). Any advice/help would be appreciated.

Just picked up a loader for my B8200. Loader has 2 controller hadles (up/dn and dump). I am assuming I have to hook the hydro hoses to the correct ports on the hydro distribution box. Problem is I don't know which goes where. Any help would be appreciated.

Thanks guys for reply on weights. My skill level is pretty low but I think I got some good tips.

Thanks for the advice. I need to get a torch and also learn how to weld. Would make my life eaiser in a lot of ways.

Need weights for the front of my B8200. New are expensive and shipping used ones not cheap either. Anyone know of a reasonable source or any suggestions on jerry-rigging something? Thanks in advance. -Mike