Recent content by Marc

Thanks all I think I found it! White coupler line was holding pressure coming back from loader. Even though I have never taken my loader off or played with the quick couplers one went bad. With the gauge I was able to see the loader block was sending fluid properly. The pin would not release...

no aux remote just standard 3pt and have been checking linkage and push rod for implement

Agreed Dan just ordered one

Agreed Dan it is ordered!

It does have quick connects! It is too intermittent IMOP why does it work so well at start up and idle? Acts just like when 3point is lever up all the way. Except instead of a slow raise I get no raise in lift cylinders but idle down and play with joystick and moves a again. Thank you for the...

Need help please! Original owner here do all my own maintenance and a decent wrench! Loader will barely lift and 3piint is not in full Max position I am aware of that issue. Fluid is at proper level. It is intermittent after using 3 point it seems. After start up loader will raise normal for one...

Hi guys needing some help. I am sorry if this was covered already having trouble navigating forums. My B3200 has 230 hrs on it. It was a quiet tractor when newer. All regular maintenance has been followed. It is a Hst and that terrible squealing pump noise in high is driving me crazy. It is...

I have noticed a new strange noise coming from under drivetrain on my tractor. 190 hours when I was plowing and cold out. I get a high pitch noise when moving in High around 1850 on up rpms. I thought it was the cold but it does it now in Spring temp at 55 or more outside. Only in high at higher...

Mine vibrates as well. Aslo when started they have a cold cylinder that misses until it clears 8 seconds or so and then thay smooth out. My bucket vibrates too I think that 60" light material makes some of the noise people are hearing. The tractor is quite loud compared to other Kubota's. Maybe...

Thank you ESERV and all, I already checked the air cleaner and it was dry but I did pull the Glow Plugs. Not too bad a job. Oil sure was down in the rear cylinders mostly 3rd one back. After that the oil hit the hood under major pressure. Put it all back fired right up and runs great! Need to...

Randi, I can not turn the fan by hand. The starter cranked it a 1/2 inch and then it seemed to bounce back to it's original position like it is under pressure. I do not want to bend a rod by trying to start it or crank it over on the balancer bolt. If it's a safety it is causing binding all...

Please help.. My new b3200 has 10 hrs on it. I had a gentle slow rollover on frozen ground with zero damage to me or the machine cosmetically. Engine was turned off with in 2 seconds of roll over at low idle when it happened. Took about 10 min with come along to flip back. Now engine will not...

Thanks for kicking me Vic. I did read the manual and you are correct! Just reved tractor not while working a load. I felt a vibration and was trying to see if it was related to rpm, I was not working at full power and then felt it. Seriously thank you. I will chill out. Had her a week and still...

Hello all I am new at owning a Kubota. I shopped the JD and after lots of pondering I moved up a size and settled on a new Kubota. I get a vibration at full throttle and it can be felt on the deck near your feet. Tractor has .9 tenths... Seems like it is on the bucket. Loader is a LA 504 with...