Recent content by iancorey

I bought a used post hole digger and the output from the gear box is 2.5" OD. All the augers I can find are 2 inch ID. I know I can get a coupling to reduce (not cheap) but I'm wondering what I've bought. Thanks in advance for any help.

That's good to know. Thanks. I'm super green.

I own a 1979 L305 (#0034) 2WD. The front wheel spindle seems to have been wallered out over time and there's a ton of play in the steering. The previous owner put steel shims in beside the top of the spindle to stabilize it a little. I'm going to try and replace the spindle. I have purchased...

> I just killed the engine and sat in the silence, surrounded by woods. I can't wait to do this in spring when the peepers are going nuts. It's just too quiet in the winter.

I'm new to the forum. I purchased some land and a used tractor to tame it for building. I'm hoping to get some good advice here. My first intended post is full of links. I can't post that until I post five other posts first. So I posted 5 links on my Kubota today. ;)

Sometimes they're the same person separated by time and experience. Sent from my Pixel 3a using Tapatalk

I have a PDF of the Shop Manual for L185-L235-L245-L275-L285-L295-L305-L345-L355. PM me if you need it.

I own a 1979 L305. I eventually would like to have a loader on the front to do some lifting. I'm currently using it to skid logs around while we clear for our build. Can anyone give me a ballpark estimate on the possibility of finding and installing this type of attachment? What about costs...