Recent content by hdhedges

Is there a scraper available that adjusts side to side in order to maintain driveway crown. Also have fairly steep driveway with water diversions berms that would need to be kept open. Box blade is not the right tool for this job. Any suggestions?

Book says not to exceed 48 inch rotary cutter[500] lbs. Any body running bigger than 48 inch? If so what are your results?

Is it adjustable?

One year old B2650 HST pedal can't find nuetral when I take my foot off. Is it adjustable?

Master system warning light comes on but tractor will not Start. Battery fine. Dealer has been notified and will come and get it. Anybody have a clue?

Do they really worK?

Pulling the box blade full of gravel up a long steep driveway my front tires tend to slip even with bucket full. If I drop into low and slow way down, traction is much better. Maybe more weight is not the solution? I find I have to raise the blade to dump some weight but then my surface finish...

Kubota needs to go back to the drawing board so you can have both at the same time. B2650 HST

Would not hurt for Kubota to revise their B2650 manual and require the whole enchilada at 50 hours. Everybody is just trying to follow the book. Experience. Experience. Experience.

Just remember, Experience is what you get when you don't get what you want. I'm getting a lot of experience.

Since I use this tractor in 4 wheel drive about 90% of the time I decided to look at the front axel oil. Surprised it was so dark, so I changed it too. Used the FEL to lift front axel up to where my oil pan would slide under the wheel and drain. Worked great. Rotella T Engine oil, $18.00...

Though I could get by with just a transmission filter change. Wrong. The transmission filter, the one facing driver left came off without incident however the HST filter facing forward on drivers right opened up the system and it gushed out. I managed to attach the new filter but had lost at...

I'm ready to change only the transmission filter on a B-2650. If I plug the transmission breather tube, how much hydraulic fluid should I expect to loose in the process?

How many of you are running spacers front or rear and what are the pros and cons since Kubota now have them as an option?

Having the privilege of operating several sizes of Kubota tractors over the past 10 or so years it was easy for me to finally select a tractor for the property and the job I currently consider to be my most pressing. Living in far west Texas in The Davis Mountains with lots of up and down we...