Recent content by Flying Biscuit

Yes I will post some pictures - after I figure out how👴🏻 - and see what you guys think. Thanks again

Thank you Wolfman. As always you are intuitive. The problem is I do have the kit, and it is not obvious where they should go. There are round seals & square seals of different sizes. Just looking for a print out of where the proper location might be. Again, thank you for any input.

Thank you for the rely. I do have that tool from days of yore when I was an auto tech. Very very handy for those inner seals. I was hoping someone had info on the order and placement of the outer rod and gland seals. Every loader is different I realize. The LA681 seams especially so. Thanks...

I have recently purchased a low hour L3710 with a LA681 loader. Wolfman has helped me with the 3PH problem repair - thank you - now I need help with the loader bucket cylinders. They had small leaks while sitting, so I took them to a hydraulic specialty shop in my area. They completely...

Thanks Wolfman. I am from Canada so went to Kubota .ca parts and found the appropriate info. The 3 point position shaft was seized in the housing. Probably from lack of use. With a wee bit of heat and a whole lot of lube it freed up nicely. Now works as it should. Thank you for all whose that...

Thanks Dan, You are correct. The link rod is actually broken. Seems the part it is connected to in the valve body is seized, or at leased not movable. Is it possible it is a bushing problem OR is there something in the valve body that is restrictive??

Good morning. First time poster. I have just purchased a 1200 hour, open station, 4WD, 2001, L3710. Everything on the machine works as it should except if you raise the 3 point hitch control lever to the top. Then the loader becomes very jerky to the point it will not raise the boom. The bucket...