Recent content by FishLife

I tried a Chaping mixes on exit sprayer today and was not impressed. It is suppose to mix the chemical and water as you spray and leave you with a tank of clean water when done so there is no waste. Also you can switch the chem tanks if you need to spray a different chem mid application. Well...

I know a lot of yall have been following along as I go through my restoration and I didnt want to leave yall hanging. I have not done anything since the hitch build. The warmer weather showed up and priorities have changed for the moment. The tractor is running and looking good so far. All that...

Got my hitch built. Posted it over in the fabrication section. Titled it, Castered Three Point Hitch.

A couple more Pictures.

I Bought a B6100 back in the fall to move some trailers around in my driveway that is hard to maneuver with my dually. The tractor moves my boat and equipment trailers just fine but doesnt have enough strength at the TPH to lift the 900 pound tongue weight of the camper. I came up with an idea...

Thank you!

Now that we are back up and running I needed to find a way to move my travel trailer around in the drive. The tractors TPH can lift the boat and dump trailers fine but the camper has to much tongue weight. After kicking some ideas around in my head I came up with this. I didnt want to go out and...

Couple more.

Some progress pictures.

***8220;Stage one***8221; completed. Time to add fluids and wanted to see what the consensus is on what transmission fluid to use. Should I use Kubota UDT, universal H/T fluid, or just and 80-90 gear oil?

Got a big surprise from USPS. My terminals showed up early. Got all the wiring done with the exception of the fuse holders. Those a pretty basic and Radio Shack has them so I will pick that up tomorrow.

Well I probably made life more difficult for me trying to source all the electrical connections to keep close to as original as possible. Probably should have just gone to the hardware store and just got off the shelf parts. Everything is trickling in slowly. Just waiting on a few terminals that...

Watching folks post on some facebook groups blowing snow with there compacts with cabs. Looks like fun but im sure by this time of year it starts to get a little old.

Any of those would work fine. I was just trying to keep it as close to OEM as possibly.

I found out that they are called a 6.3mm 9p connector. Typed that in to google and found them everywhere. Thanks for everybodys help on this one.