Recent content by evan4434

B2650 has that

Took a l2501 out today and I am sold on it. Now I need to find the best deal!

Ok I am pretty set on the L2501 now and when to buy. I can get a new one with loader, 6' rear blade for $17k. When does Kubota run the best deals now, spring, or some other time?

So no DPF, EGR, EGR cooler any of that stuff? Thanks

So I have looked hard at the B2650 and the L2501. The L2501 looks to be a heaver unit and looks like it could handle the abuse I would give it better. When I look at Kubota's site it looks like both these units are running the DPF tier 4 junk. When did they start putting this stuff on the L2501...

What is the smallest 25-30 hp that has the bucket disconnect like a skid loader? Is it a b3350? Do they make one without any of the emissions BS?

Do b3200 have emissions equipment on them since they are over 30 hp?

I am looking at selling my B7100 HST with loader and buying a bigger tractor between 25 hp and 30 hp. My B7100 has been one tough SOB, and I want to replace it with something just a tough but bigger. Any idea on what Kubota model number would be a good replacement? I like the loader joystick...

Anyone know of a good grapple kit without spending $2000 for third function hydraulic kit and a grapple?

I can't rember right now but any UDT hydro fluid should work plus look at the back of the bottle it will say if it will work with Kubota UDT. good luck

I read the entire thread you sent, and it was somewhat helpful. I need to know the size of the roll pin? Also what goes on the other side of the driveshaft cover. I noticed in the photo's on the thread you posted his boot was missing on the transmission side as well. Thank you for the help.

What size is that roll pin? Mine is broken to, and I need to get a new one. Thanks

Man finding part diagrams is a pain for these tractors. What size is that pin that holds they yolk onto the transmission? Also there is a steel tube (shaft protector) over the front driveshaft. The front of that tube has a rubber boot on it. The back of the tube is missing what would appear to...

Well just checked it, and sure enough the front drive shaft is missing the pin that holds it onto the transmission right on the yoke/shaft.

I will give the driveshaft a shake. It does it in 2 or 4 wheel drive.