Recent content by edigert

Thank you for all the useful information. The only reason I got a new o-ring is because there was one on it when I tore it apart. We bought the zd 323 mower new, so I am almost positive it had not been tore down before we bought it. The gasket I got is exactly like the one I took off. I...

Thanks for your reply. I know where the oil port is I just need to know where where to put the o-ring. On top of the gasket or under the gasket. I cant remember where it was when I tore the motor down.

I have a zd-323 mower that i am rebuilding due to accidentally opening the coolant drain on the side of the motor while changing fuel filters resulting in overheating. I have fixed that drain with a plug btw. Block was honed and cylinders within spec. I had the head checked as well for...

Thank you for your reply. I will align and put it on. I had it on once but then the wsm said it needed to be aligned with the timing marks on flywheel.

I am rebuilding a d-902 and have a question about the flywheel installation. This motor is out of a zd-323 mower. I have a manual and it shows an alignment mark on the rear end plate. The motor only has a rear end plate on one side but not the other where the manual shows the alignment mark...

Looking for a manual for a D 902 E3 engine. I have looked everywhere with no luck so far. Any help would be greatly appreciated. Thanks