Recent content by davidbham

I added the kubota remote kit several years ago, giving me two rear remotes. I have a top cylinder, from a previous B7100HST. I just haven't found a tilt cylinder. I went ahead and bought the HSL2202 cylinder from ebay. The short answer is no, it is not a drop in fit. The upper holes are...

Look at the last posted pic on the ad. It shows specs of 11 7/8" to closest hole on bottom clevis. I measured my link at app 11 3/4 center to center. I extended my link to about 15 1/2", so it gets maybe 1/2 inch more extension than the cylinder, which is listed as a 3 5/16 inch stroke. By...

There is an EBay listing for a level tilt cylinder - Kubota b8200 9200 side link hydraulic leveling tilt cylinder Tisco Ts hsl 2202 for $121. Has anyone tried this on a BX? It looks close enough to work and the price is right.

The specs say the hitch is a cat 1, the driveline is a cat 3. I think the driveline specs are based on HP at the pto. http://www.landpride.com/ari/attach/lp/public/specs/312-556s.pdf I ran a 48" Kodiak rotary cutter with my former B7100HST without problems.

Re: Belly mower cutting height adjustment and finding the "top" position. Thanks for the great advice - it solved my problem on getting to "TOP". Suggested modification to above instructions - before making adjustment, LOWER deck all the way so weight is resting on gauge wheels. This way the...

I saw a pic of some guy's Kubota MMM in his garage, perhaps on this website. It was stored vertically on what looked like the four standard rollers, two connected together at each of the two rear wheel sleeves. Anyone know what his trick is to do this?

I've looked at the quick attach bucket hooks at BXexpanded.com. http://bxpanded.com/index.php?l=product_detail&p=6 They look great but are really pricey to me. Are there any aother no drill, no weld alternatives out there? ( I like this concept as you can place them where you want whenever.)

Forgot to put the pics up, here they are:

I found this hydraulic top link at http://www.agrisupply.com item # 67464 HYDRAULIC TOP LINK CATEGORY 1, 2" X8" STROKE This one has a tang on the base end. On my B7100, the top link is mounted between the bases of the ROPS, and needed the extension. I'll run it from the directional control...

I don't know if it matters, but you'll notice you have the turnbuckles installed on the outside of the lower lift arms. The factory set up is to have the turnbuckles on the inside, as in Eric's picture.

Steve, Tell me about the cylinder you used and how you plumbed it. I see both ports of the cylinder seem to be connected to the same line. Is there any directional flow control on either of the ports?

Steve, I guess my primary use for the hydro toplink will be to adjust the tilt of the bush hog as the slope changes. Would I have to throttle down to lower the cylinder with the single hose set up you have? David

Steve, I guess my primary use for the hydro toplink will be to adjust the tilt of the bush hog as the slope changes. Would I have to throttle down to lower the cylinder with the single hose set up you have? David

I am also trying to tap the hydraulics on my B7100HST to add a hydraulic top link. The manual says to "Remove the plug from the front case cover, and connect the return hose to the cover." In the attached picture, do I have the correct item circled (is that "the plug from the front case...

Thank for the good word, dlumpy5282. I hope it works well for you. Also, thanks for the smooth transaction. dlumpy5282 was a great buyer. David