Recent content by Comanche

Yes, it is still available.

Kubota Debris Blower for leaves Uses standard Kubota quick attach Fits Kubota F-Series machines - was used with an F3680. Leaf blower needs a front tire and chute is a little banged up. Does not come with motor to adjust chute. (I bought a couple of these, and neither came with a chute motor...

L2072-1 blade - works excellent, but has been stored outside and deserves a good paint job at some point. Slight bend on one side. L2054B quick attach undercarriage with driveshaft - driveshaft is used to power a brush or snow blower. Used residentially last few years with no issues. Selling...

Thanks for taking a look. I'm guessing the machine side is very similar to a shaft that would drive a deck or brush. The snow blower side would just have the wrong yoke on it. If someone has a spare F3680 PTO shaft of any type that they would be willing to part with, I could probably shorten...

Recently purchased an F3680 that came with an F5210B snow blower - I need a PTO shaft for that snow blower - it is different than the shaft used for a brush or debris blower. Blower PTO connection point is 1 1/8" OD.

If you are still looking, I have one in Grand Rapids, MI. PM sent.

PM sent.

For the record, I did get the PLV22TSTKAB and the power beyond sleeve installed last night. The Kubota fittings did not need any adaptors, they properly threaded directly into the Brand valve. The only thing that took a minute to figure out was that the front/rear inlet and outlet were on...

Sounds good, thank you.

Do you have any 27 x 10.5 x 15 turf tires? I may need one or two, found a set locally but they are mismatched and not the same size even though they have the same numbers, one is a Carlisle Multi Trac and I’ll have to check on the other.

Thanks! Looks like the power beyond sleeve for this unit is MSLV2-W. If you have worked with the Brand unit at all... do you know if I am going to need adapter fittings or if the fitting threads are the same?

I have an L2650 with the LA450 loader. Previously well used and abused by a tree service company. I have the following issues: -no down pressure (in the winter this becomes a front blade that will not angle right, only left) -lots of slop in the control valve -very sensitive/jerky controls I'd...

Looking for two of 420/70-24.

Thanks for the tip! Mine are functional for now, so I'm going to hold out for a decent used set, but we'll see what happens.

I have a Kubota L2650 and am looking for two rear rims. Original owner had calcium chloride in the rims and they are about done. If they come with Ag or R4 tires, that would be fine. My tire size is 420/70-24. I believe the original rim part number to be 35060-27840. I would be interested in...