Recent content by clee991

Re: D722 injector pump advice needed #SOLVED Well it took the 6th try to get the right spring! And everything went back together and is running perfectly. The breakthrough for the parts guys was when they realized that the parts diagram shows a single governor spring when there is in fact two...

Update - Bobcat dealer 0 for 2 on getting the right governor spring. Then Kubota dealer went 0 for 2 so far. Fifth attempt arriving next week through Kubota. We shall see. Doesn't reflect well on either company's parts systems.

I could reach the governor arm with a finger and it moved very freely. Too freely. I made a hook and fairly quickly found the pump rack and out popped the IP. The rack was moving freely in the injection pump but every so often it would go tight at the extreme end of travel (away from the...

I tried picking under the pump but it just felt like I was on the aligning dowels. I ran out of photoo space in tis forum so have a google photo album with more in it (with correct orientation) https://photos.app.goo.gl/RzFb3WoyFLVPT1339 looking into the speed control cavity from the side

Before any further disassembly, I probed the channel where the solenoid fits into with a chunk of stiff wire and confirmed that there is no movement which would be consistent with it stuck in shutoff position. I lifted the speed control plate and removed the governor spring. But now I am...

@thepumpguysc I can raise the IP far enough to get a piece of gas line under and fill the case with the ATF & Acetone mix. Just confirming that the IP case doesn't drain into anything else? Will I be able to clean out after and not contaminate where I shouldn't? Not quite sure what you mean "U...

@rentthis / @jerryMT out of an abundance of caution I have blown back through the inlet as you suggest - good low-pressure flow at all points from tank through the electric pump and return to the tank @thepumpguysc attached the WSM page S35 I am working from. It shows the slot you have...

First post here - looks like a great forum and already gained valuable insights - thanks! I have a Bobcat 2200 UTV with a Kubota D722 engine with 1800hrs. Was starting (even in cold) and running clean without issues. FYI this unit has electric inline fuel pump and electric shutoff solenoid. It...