Recent content by carp1

Got it. Thanks Glow plugs culprit appears to be corrded switch terminal. Starter Culprit was corroded terminals on clutch switch. Switch was good. The temperature gage and oil and charging lights was the fuse block. Fuse was good but just not getting contact on the down side of the...

I tried the system voltage drop test and voltage dropped from 12.71 to 12.56 with the load tester. These readings were with the black lead hooked to the negative terminal. When I ground the black lead to the frame I get 2 or more volt drop in both sides. Additionally the voltage at all the...

Thanks Dave for the wiring diagram. I have 12.75 volts at starter, both sides of the thermal fuse, the main switch on all lugs as key is turned, the starter switch for both the glow plugs and starter as switch is turned. The clutch pedal switch tested good. Still no glow plugs or starter...

Will check these next week when I get back. Thanks guys for the information.

Cleaned off the fuse area with contact cleaner. I did notice that the fuse terminal 2nd from bottom had 11 volts instead of 12+. Trying to figure what each fuse is to.

Checked battery connection Good. checked fuse at panel look good and have power to both sides as switch is turned. Switch seems good. I used to get a low oil light and charge light on when switch turned to on. Then they went off when tractor started. Now they are off. No juice to glow plug...

A week or so ago with the great help from folks on the forum I replaced the copper washers to fix an injector leak on my L295DT. I was running the starter several times about 10 to 15 seconds at a time to prime the system. The starter was turning over reasonably well. Then on the 4th try the...

Thanks for the information. My return lines are rubber hose but there is a nut with a nozzle holding them. That will make it easier. Will finish up on this next week. The injectors seemed to work great other than a slight leak. Does the dealer check them or do I have to send them off...

Does the injector come out as a unit by loosening the bottom part or does it come out in stages? Is there a special tool to loosen the bottom nut. Thanks again. please excuse the picture. Ive dropped this phone so many times the camera is bad

Thanks for the advice. Randy

Have slight leak around injector. Looks like the little copper ring/washer. It looks simple fix just unscrew injector and replace copper washer. Is there anything I am missing? (I have had simple jobs go sideways fast). Will probably do all 3. Thanks for any heads up. Randy

Already took it to local hydraulic shop. They listed a number of things that were wrong with it. Told me it would be cheaper to look for a new one.

I will give them a try. Thanks

I have an old L295DT with a loader. I think the loader is a model 1200 and the cylinder is a part number 4361. Took the cylinder in to repack. they said it was pretty much shot. So Im looking for an aftermarket cylinder. Messicks did not have one. Anyone know of a source.

I just tapped it out and put a bolt with a nylon washer (like oil drain plug) in the hole. Used metric bolt just to be consistent. So far no leaks.