Recent content by Avery

checked the pressure at control valve as you suggested, it went to 2,200lbs, but, the lift part of the loader is real slow. put new seals in control valve and that didn't help. I put the bucket tilt lines (they worked fine on bucket tilt) on the loader lift and they didn't help the problem. Do...

Thank you , the starting problem was a bad glow plug. Now I'm working on the hydraulic loader. The loader raises very very slow and not much lifting power. The tilt on the bucket works just fine and so does the three point on the back. I checked the hydraulic pressure at the control...

Thank you for the information

Should I check the resistance in the glow plugs before I take them out with the power wire off? What should I torque the injectors at? I don't have a manual Should I put anti-sieze on the thread? Thanks

Yes, I've had the tractor for 20+ yrs in running condition but getting tired. It had only been a couple of days since I had used it and it wouldn't start. I've been posting questions for the last week or so trying to trouble shoot the problem so I took the injectors out. thanks

Finally took the injectors out, tested each one while turning the tractor over got a nice spray out of each one of them. I didn't hear any popping noise. Should I still have them rebuilt? (unfamiliar with diesel engines) Thanks

Yes, I've had this tractor 20 plus years. I replaced some gears in it this winter. I have a hydraulic problem with the loader, parked it in the back of the barn for bout a week and it wouldn't start. Just a bunch of black smoke. Last summer it was smoking alot, put some lucus injector...

Battery charged , engine spinning over fast with the compression release engaged. I opened the nut near the injectors again getting little squirts of fuel out starting with the longest line from the injector pump. Shutting the nut off while the engine is still spinning to make sure there is no...

i don't have a ir gun but i will get one thanks

I've tried bleeding it a whole lot trying to get air out but I don't see any air. Guess I'll try it again, I do try it with the compression release engaged trying to get the air out. Then I disengage it and leave the glow plugs on for a while, nothing happens just smoke coming out of the...

The starting issue happened all at once. Do you guys have anymore suggestions? Do you think something is wrong with the injector pump? Thanks

I know I'm getting power to the glow plugs. The temperature outside is in the low 60's. Tractor has always started, sometimes with a little effort. I've been cracking open injector line individually at the injector. Don't see any air or much fluid coming out. Should I put in new glow...

Have tried with the throttle wide open . with the nut cracked open at the injector not much diesel coming out Thanks for the help

I have a kubota L345 v1500 engine. Turns over fine but won't start. Put a new fuel pump on so I'm getting plenty fuel to the injector pump. Opened the bleeder valve made sure there was no air. So I cracked open the line at the injectors- how much pressure should there be? it doesn't seem...