Recent content by aasu03

I'm not shy... (9One2)9Nine6-1Eight87 (Mod edit: Crooks and spammers arn't shy either.)

I couldn't find a single number on top of my radiator. So it goes.

When it rains it pours... So apparently Kubota raised their prices on parts so says the parts-guy from Lawneq.com and it's not $475+S&H not $399 delivered as it was last freaking week on their website!!!

In the event it does jive.... Whatcha want for that there radiator?

Well boys.... despite my good ol' college try the epoxy didn't properly bond with the plastic. I was able to pick it off along the edges and wound up pulling a good bit off with needle-nose pliers in my frustration to see just how crappy my idea was. Coincidentally I started thinking of what...

After driving over some small trees I noticed my hydraulic filters had sustained some dents. I made this to protect it from errant limbs as well as anything I may drive over. I replaced the filter after fitting the under armor. I hope you enjoy!

$300??? Where in the world are you finding your radiators? I'd likely forego the hassle of the college-try if I could find one for $300. Red Rover, Red Rover, send the link on over!

By the time I get all that set-up I could likely have re-installed the radiator. Would it be too risky to just run the tractor for a bit hoping it holds and shutdown the moment I see a leak?

So here’s where I’m at... I’ve removed the radiator, cleaned the area, and then I used my soldering iron to melt/close the cracks running away from the hole. I added an epoxy used for nylon/plastic. I hope the photos work. Also, I figured I’d go ahead and replace all the hoses (coolant...

Engine warping.... I don't even want to think about that! The fiberglass wrap is a great idea! I'll try to get some photos up soon, the holidays and my kayaking trips may delay it some though. www.blackwaterpaddleclub.com

I've decided to give it the ol' college-try and repair the broken plastic inlet with some epoxy. My only concern there is will the vibration & jarring cause a failure. I do plan to replace a few additional parts as well such as both radiator hoses, thermostat & gasket, rubber feet for the...

Yeah I did forget that info... Sorry, 2012 L3800HST 4WD

So yesterday I was bush hogging and a mean-stick poked into my engine compartment right where the lower radiator hose connects to the lower radiator inlet and broke the plastic inlet pipe. Aside from why in the world it was made out of plastic.... Does anybody have the part number and a cheap...

Hello all... I've got an L3800 and I recently purchased some land that has about 7-8 years of undergrowth that I'd like to mostly clear as it was clear cut back then. I'm considering a King Kutter L60-60-HD and possibly a Wildkat tree shear to attach to the QD bucket (I do have front remote...